I posted on your thread over on the Remote Central Forum...
my post there is repeated below
Basically i was wondering if your devices/ code can be of any use in my setup.
I'll repeat the post here, below..
Trawl your way through it, see if you understand what I am asking and we can go from there.
I have followed the link and I strongly suspect it is. I see the A IR nano shield and various other projects, but am unsure what I want/need or if your project is what I need at all.
Currently I run a Raspberry Pi with HA-Bridge and heyu to control X-10 powerline devices.
To add IR reception to the RPi to allow X-10 control of devices within the same system would be the goal.
I have successfully tied in a HomeVision device to receive IR to control X-10 in conjunction with a harmony Remote and Hub.
Harmony only sees X-10 devices via the 'fake' Philips hue HA-bridge emulator..as lights...so cannot control the X-10 devices until AFTER/THE END of scene creation..absolutely useless...so creating a fake entertainment device called X-10 allows the Harmony to turn on -10 devices at the start of a scene.
Doing it this way works..but it does mean I now have two Raspberry Pi's and two X-10 serial to powerline device running. No big thhing but it is duplicating everything.
I have one RPi running the HA-bridge emulator / heyu driving the CM11 to send X-10 commands and now also the HomeVision device (and is associated RPi) and its TW-523 powerline unit sending X-10 signals.
The HomeVision /TW-523 is an extra device that could be removed to simplify the whoel system if I could just get IR reception and decoding in to the Raspberry Pi and get that to drive heyu and the CM-11 directly.
this is the HV controller if yo have not seen them.
So to sum up .
Does your device and code allow IR reception on my currently running RPi and driving the heyu application on the Pi ?