tsop58000 not giving correct timings

Everything related to protocols and IR codes
Post Reply
Arun10m
Posts: 4
Joined: Tue Oct 30, 2018 11:36 am

tsop58000 not giving correct timings

Post by Arun10m »

hi
tsop58000 in arduino not giving correct timings , circuit used as mentioned in datasheet.

https://www.analysir.com/blog/2014/03/1 ... s-arduino/
i used this program only
User avatar
AnalysIR
Site Admin
Posts: 776
Joined: Sat Aug 31, 2013 3:51 pm
Location: Dublin, Ireland
Contact:

Re: tsop58000 not giving correct timings

Post by AnalysIR »

I will assume you mean TSMP58000 (vs tsop58000 )

The sketch you linked is not designed for that IR Learner, which outputs a modulated IR signal.

You can try something like a TSOP34438 or similar, with that sketch.

There is also a post on our blog which shows how to use an IR receiver, to capture an IR signal.


With AnalysIR, we also provide firmware that makes use of both a TSOP IR receiver and also an optional TSMP58000(just to capture the carrier frequency).
Arun10m
Posts: 4
Joined: Tue Oct 30, 2018 11:36 am

Re: tsop58000 not giving correct timings

Post by Arun10m »

how to find the frequency of the signal?
User avatar
AnalysIR
Site Admin
Posts: 776
Joined: Sat Aug 31, 2013 3:51 pm
Location: Dublin, Ireland
Contact:

Re: tsop58000 not giving correct timings

Post by AnalysIR »

If you post the device you are trying to control, I might know the answer.

Alternatively, just try/test all the common frequencies [30,33,36.38,40,56]kHz and use the one that works.

For a better solution, most of the modules in our webshop(link in the header above), measure carrier frequency when used with our AnalysIR application.

IRLIB may also support this, using the TSMP58000.

You could also try this from our blog: https://www.analysir.com/blog/2014/05/2 ... eceiver-2/

It may also work with a tsmp58000 (I have not tested that),- you will probably have to adjust the code to account for the inverted logiv of the TSMP.
Post Reply