Response is below:....
I do have a question: In the KontroLIR demo firmware (KontroLIR.ino) in the file KIR_header.h you define some macros like this:
#define LEDON SetPinHIGH(E, PE3)
#define LEDOFF SetPinLOW(E, PE3)
I haven't been able to find where E and PE3 are defined. They work but they seem to come out of nowhere. Which header file are those from please?
E is port E on the AVR MCU
PE3 is a pin number on the ATmega328PB - it has a few xtra pins over the normal arduino ATmega328P (in PORTE)
SetPinHigh is a macro which allows fast setting of pins directly instead of using the slower Arduino digitalWrite().
The macros are defined in KIR_header.h
// PORT Level Pin manipulation - much faster access than Arduino defaults
#define SetPinINPUT(port, pin) DDR##port &= ~(1 << pin)
#define SetPinOUTPUT(port, pin) DDR##port |= (1 << pin)
#define SetPinHIGH(port, pin) PORT##port |= (1 << pin)
#define SetPinLOW(port, pin) PORT##port &= ~(1 << pin)
#define TogglePin(port, pin) PORT##port ^= (1 << pin)
The ## is a concatenation syntax. So in your example
is converted to PORTE |=(1<<PE3), by the pre-compiler on the PC IDE only...so there is no actual runtime overhead on the MCU.
.....which is the fastest way of setting a pin, using direct register access.
PORTE & PE3 would be defined in the AVR includes which happen as part of the Arduino subsystem/core definition, which may not be visible in the IDE.
....hope this helps